Belts and Top Covers

Install Guide

Belt Routing

  • You can now loosely route the belts thought the idlers but do not pull to hard as it will pull the pins out and Idlers with them!

    • Front Idlers

  • Remove the "Front Idler Blocks" from the "Front Idler Mounts". Wrap the belt around the Idlers, slide them back into the "Front Idler Mounts" and run the M5x12mm "Front Idler Adjustment" screw in about 1-2 turns.

    • Motor Mount Tops

    1. Remove the Rear "Gantry Braces" from earlier.
    2. Using (3) M5x10mm screws and Hammer/Roll-In T Nuts (Hammer T Nuts seem to be easier here) mount the "A Drive Upper Right" and "B Drive Upper Left" plates top on.

      3. ...

    3. Replace the Rear "Gantry Braces" and tighen down.

    Jointer Tops

  • Install the "Jointer Right Top" and "Jointer Left Top", use (1) M5x35mm and (1) M5 Locknut for each side.
    • ...